Sort By:  
Pilot-RC Laser 73" (1850mm) - white/red/black (4ST1973L-WB)
Pilot-RC Laser - radio controlled 3D airplane model (white, red and black paint scheme)

It has arrived! The 30cc version of Pilot-RC rule changing Laser 73" (1850mm)!

Fully designed from the ground up for out and out performance, keeping in line with current demand for faster, more aggressive and more agile models, while still keeping the well known great flying characteristics of Pilot-RC models.

Check the videos in our Video tab to see this model in action to fully understand its capability. Its not a question if the plane is quick enough, its whether you can keep up with it!

Model: Laser
Wingspan: 1.850mm (73″)
Length: 1.760mm
Weight: 5.2kg

NEW! Hybrid construction from wood and composite materials for specially reinforced fuselage and wings.
NEW! Patented quick assembly system for wings.
NEW! Patented quick assembly system for canopy. Especially useful for electric version, fast battery change!
Genuine German Oracover (Ultracote) covering
Highly prefabricated, experienced builders can have it air ready in under a day
Pre-installed hinges (glued and pinned)
Easy canister installation due to open construction
Removable wings
Laser engraved motor mounting position
Pull-Pull system for Rudder servo
Cowl fits both gasoline and electric motors
Can use single elevator servo, or choose to split the elevator half and use two separate servos.
Designed for both single cylinder and twin cylinder engines!

Included hardware:
Complete air frame with all basic accessories (such as carbon fibre main undercarriage, tail-gear assembly and wing-tubes as well as fiberglass control horns and wheel pants)
Pre-installed hinges and pre-mounted canopy
Fuel tank and fuel tubing pre-installed, fuel dot and breather valve
Wheels, axels and wheel pants
Pre-prepared pull-pull wires and pushrods with ball links
Matching carbon spinner

Required hardware:
Motor: 30-40cc or equivalent electric (Recomended O.S. Engines Gasoline Engine GT33)

Servos: 4 or 5 high torque (minimum 20kg) plus throttle servo
(uses x1 per aileron, x1 or x2 (optional) for the elevator and x1 on rudder)

Also requires all the usual accessories such as transmitter, receiver, propeller, batteries, extension leads and possibly other small accessories.

699.06€  Inc Tax
Pilot-RC Generic Wingbags for 35cc Airplanes (4ST17410)
The perfect way to protect your model while at home or in the car. Keep all your models components together in the same place with Pilot-Rc wingbags.

Our generic wingbags are designed to fit our Pilot-RC acrobatic models, however will fit mostly any model. Please see measurements in the table below:

SizeColours available

35ccRed &
60ccRed & Black 42100281021203760120
100ccRed & Black 48109311101253867126
150ccRed & Black 56132411331434482144

*All sizes are shown in cm. Measurements A-D are elevator pouch, E-H are main wing compartment. Actual sizes may have minor variations due to fabric construction.

Bags include separate compartments for each wing, for wingtube, and for elevators.

Use this storage/carry case for radio controlled (RC) airplane models and its accessories.

69.54€  Inc Tax
Per Page      1 - 2 of 2
  • 1