Chargers & Power Supplies

Sort By:  
SkyRC e3 LiPo (2-3s) Balance Charger (SK100081)
SkyRC e3 LiPo (2-3s) Balance Charger

SkyRC e3 AC balance charger is designed for 2‐3s LiPo battery. Its simpliness and low‐cost make it not only popular in RC world but also find its place in airsoft market.

Specifications
AC Input: 100-240V
Battery Type: LiPo
Cell Count: 2-3 cells
Charge Current: 1.2A
Circuit Power: 11W
Weight: 103g

Size
Length: 88mm
Width: 57mm
Height: 35mm

18.30€  Inc Tax
Graupner XH-Balance Charger 3-4S LiPo (GR3S4SBAL)
Graupner XH-Balance Charger 3-4S LiPo

Microprocessor controlled charger with integrated balancer for lithium batteries (LiPo, LiIo).

7-segment LED voltage and charge status indicator
For LiPo batteries with 3-4 cells and XH balancer connector
Charging power: approx. 40 W
Charging current: max. 3 A
Weight: 135 g
Automatic test and detection of batterie cells

Technical data:

Connector: XH
Width [mm]: 60
Height [mm]: 26
Weight [g]: 135
Max. charging current [A]: 3
Number of LiPo, Lilo cells: 3 - 4
Length [mm]: 98
AC input voltage [V]: 100 ... 240 V AC
Dimensions: [LxWxH in mm]: 98 x 60 x 26
Max. charging power [W]: 40

Use this 3-4S LiPo battery Balance Charger for radio controlled (RC) model airplanes, helicopters, cars, trucks, buggies, boats and other Lipo batteries.

14.64€  Inc Tax
SkyRC eFuel 380W 16A 24V Power Supply (SK200023)
SkyRC eFuel 380W 16A 24V Power Supply Unit

Built for most demanding pocket charger 
Converts standard household power 100-240V AC to 24V DC power and supply up to 16 amperes of continuous power.

Safer and Reliable
  • Short-circuit protection on output
  • Over Current Protection
  • Over Temperature Protection
  • Over Load Protection
  • Over Voltage Protection

Active PFC
Active PFC is the use of power electronics to change the waveform of current drawn by a load to improve the power factor, thus achieving the purpose of higher efficiency. Active PFC, which is integrated into SkyRC 380W/16A regulated power supply, can provide higher power utilization.

Intelligent Air Cooling System
Adopting the cooling system, the fan will be initiated automatically when operating temperature reaches 50 degree.

Overload/Error Indication
The LED indicator turn red whenever equipment connected to the Power Supply is drawing more power than it can provide. The Power Supply may shut down turning off its output in order to protect its circuitry from damage.

Rigorous testing, derived from the pursuit of quality
Each 380W power supply must experience dozens of more than the industry standard of critical testing. Each rigorous testing and every detailing are the reflections of SkyRC's concentration on products.

Specification 
Converts standard household power 100-240V AC to 24V DC power and supply up to 16 amperes of continuous power.

Size and Weight
Case Size:165x139x59.5mm
Weight:1.11kg

Power Supply
Voltage:100-240V
Input AC Frequency:50-60Hz
Output Current:16A
Output Voltage:24V DC±0.5V
Output Voltage Ripple:<300mV
Power Efficiency:88%
Power Factor:>0.98

Protection
Current Overload Protection:17A ±1A
Over Temperature Protection:<80℃
Cooling Method: Cooling Fan 
Operating Temperature:0-40℃
Operating Humidity:0-90%


89.06€  Inc Tax
RAYTRONIC C30 Plus DC Balance Charger 300W (3EC1030P)
The Raytronic C30+ (300W) was designed in mind with high performance and very simple operation. Raytronic C30+ allow charging and discharging most common types of cells (NiCd, NiMh, LiPo, LiHV, Li-ion, LiFe, Pb), and is equipped with a built-in six-channel balancer, which ensures safe charging of lithium batteries. It offers also a measurement of voltage and internal resistance of individual cells (for lithium batteries).

Features:
Input supply voltage 10 - 26 V DC (socket XT60) For charging and discharging 1 - 16 NiCd / NiMH cells, 1 - 6 Li-ion / LiPo / LiHV / LiFe cells or 2- 20 V lead-acid batteries
Adjustable charging current (0.1 A - 12.0 A)
Adjustable discharge current (0.1 A - 3.0 A)
Max. power for charging 300 W, for discharging 5 W
Termination of charging using delta-peak automation for NiCd and NiMH batteries
Lithium and Pb batteries are charged using the "constant current / constant voltage" method
Adjustable delta-peak detection sensitivity for NiCd and NiMH batteries
Adjustable end voltage for charging and discharging for lithium batteries
Repeated cyclic operation of charging / discharging or discharging / charging for NiCd and NiMH batteries, up to 5 cycles
Four charging modes for lithium batteries - normal charging, fast charging, balancing charging and storage charging / discharging
Stop charging when the set time or the supplied charge is exceeded.
Memory for 5 charging / discharging programs.
Measurement of the total voltage of the set and individual cells (for lithium batteries)
Measurement of the total internal resistance of the set and individual cells (for lithium batteries)
The XT60 power output socket and the JST-XH 2-6S universal balancer socket allow you to connect the rechargeable battery directly without the need for a charging cable and balancer adapter (if the kit is equipped with an XT60 power connector and a JST-XH service connector) Two-line backlit LCD display with simple and clear menu and display of parameters during charging / discharging
A number of warning text messages contribute to safe operation - incorrect input voltage, incorrect connection, unsuitable battery or its condition, incorrect polarity at the output
Reverse polarity and short circuit protection at the output / li>
Compact plastic case, small dimensions
Built-in fan for forced cooling

Specifications:
Input voltage [V]: 10 - 26
Charging current [A]: 0.1 - 12
Discharge current [A]: 0.1 - 3
Number of channels: 1
NiCd: 1 - 16
NiMH: 1 - 16
Li-Pol: 1 - 6
Li-Ion: 1 - 6
Li-Fe: 1 - 6
Li-HV: 1 - 6
Pb: 1 - 10
Balancer: Yes
Charging power [W]: 300
Discharge power [W]: 5
Balancer current [A]: 1
Length [mm]: 87.5
Width [mm]: 48.5
Height [mm]: 30
Weight [g]: 95

29.89€  Inc Tax
SkyRC Temperature Sensor for SkyRC Charger (SK600040)
SkyRC Temperature Sensor for SkyRC Charger

9.76€  Inc Tax
Graupner XH-Balance Charger 2-3S LiPo (GR6454.XH)
Graupner XH-Balance Charger 2-3S LiPo

Use this 2-3S LiPo battery Balance Charger for radio controlled (RC) model airplanes, helicopters, cars, trucks, buggies, boats and other Lipo batteries.

9.76€  Inc Tax
SkyRC NC1500 AA/AAA Battery Charger & Analyzer (SK100154)
SkyRC NC1500 AA/AAA Battery Charger & Analyzer

What matters during the charging process, especially for AA/AAA NiMH battery charging? No doubt, accuracy and safety! The creation of NC1500 not only arises out of the need but also from the desire to have a simple but safe and accurate charger for the battery. NC1500 has four independent slots and supports AA/AAA NiMH batteries, offers a maximum charge rate of 1500mA.

Four Independent Slot
1-4 pcs of NiMH AA, or AAA can be charged at the same time in any combinations.

3 Working Modes
Charge Mode
Discharge Mode
Battery Refresh MODE

Battery Internal Resistance Detection & Advanced Safety Features 
*At the start of a program, the device always performs a quick standard test first in order to determine the internal battery resistance. Aged or poor condition batteries have a higher IR and therefore heat up more during charge or discharge. The values are estimates and will vary depending on the state of the batteries and operation environment.

Convenient Operation
Powered by smartphone charger, any standard USB adaptor, power banks, and car chargers.

Rugged Durability and Pocket-size

Charging Time with Various Charging Current
Charge time is a guide only. Timing may differ according to brands/mAh capacity and environment conditions at the time of charge.

Specifications
USB Input Power: 5V/2.1A
Trickle Current: 50mA
Operation Mode: CHARGE, DISCHARGE and REFRESH
Operating Temperature: 0 ~ 45 ℃
Charge Current: 200mA / 500mA / 700mA / 1000mA / 1500mA
Discharge Current: 100mA / 250mA / 350mA / 500mA / 650mA
Max Charging Capacity: 3000 mAh
Weight: 106g
Size: 108*73*28mm

29.89€  Inc Tax
SkyRC Dual Charging (Port) Balancer Board with XH adaptor (SK600071)
SkyRC Dual Charging (Port) Balancer Board with XH adapter

Specification:
Cell: 2-8S LiPo
Connector: XT60 for battery / XH balance ports
Fuse: 2x 40A

25.01€  Inc Tax
Per Page      1 - 8 of 8
  • 1